1 5
Your child restraint has two (2) recline positions for use in Harness Mode only.
Place the child restraint in the desired seating position. Lift the recline handle
found underneath the front of the seat
(12, 13)
and adjust the base to the
desired angle
(14)
. Release the handle when done and gently push on the seat
to ensure it is firmly locked in place. An audible ‘click’ will ensure it is locked in
place.
Please Use tHe recline tHat alloWs For tHe Best and tigHtest
installation.
!
recline cannot Be Used in Booster Mode (groUP ii / iii).
!
Use
onlY
the vehicle’s 3-point lap-and-shoulder belt system when restraining this
child restraint to the vehicle
(15)
.
do not
use this child restraint with a 2-point
vehicle belt
(16)
. Your child would be seriously injured in the event of a crash.
Please Use tHe recline tHat alloWs For tHe Best and tigHtest
installation
(17)
.
Headrest HeigHt adJUstMents #1 - #4 can Be Used in Harness Mode.
1. Place the child restraint flush against a forward-facing vehicle seat. The vehicle
seat
MUst
be equipped with a 3-point lap-and-shoulder belt. The child
restraint must be level, stable and not rock side-to-side.
2. Thread the vehicle shoulder belt portion of the seat belt through the backrest belt
guide on top of backrest
on tHe saMe side
as the seat belt retractor
(18)
.
3. Open harness system and lift insert cushion. Thread the lap portion of the
vehicle’s seat belt through the red belt base positioning guide
on tHe saMe
side
as the seat belt retractor
(18)
. Replace insert cushion.
4. From
BeHind
the child restraint, pass both the lap and shoulder portions
around the rear of the seat and back through the opening
(18)
on the opposite
side of the seat as indicated
(19)
. Take both portions of the vehicle seat belt
and guide them over the side of the child restraint
(20)
.
5. Buckle the vehicle seat belt. Listen for an audible “click”
(20)
. The vehicle seat
belt
MUst not
be twisted.
6. If your vehicle is equipped with a ELR/ALR switchable seat belt retractor system,
we recommend that you pull out the full length of the vehicle seat belt (until you
cannot pull out any more slack). This locks the retractor. If not equipped with
switchable ELR/ALR retractor, continue with step #7.
7. Tighten vehicle seat belt by placing your knee on the child restraint base and
by using your full weight to push the child restraint down as you simultaneously
r e c l i n e
i n s ta l l i n g W i t H V e H i c l e s e at B e lt
g r o U P 1 ( 9 - 1 8 Kg )
Summary of Contents for Vybe Deluxe
