![Harmonic Drive HS-360 Series Manual Download Page 28](http://html1.mh-extra.com/html/harmonic-drive/hs-360-series/hs-360-series_manual_3984819028.webp)
Chapter 4
Installing driver
- -
22
(5) The driver input power supply voltage is shown in the "INPUT VOL." on the nameplate and at the
top of the front panel of the driver. (Refer to Section 1-6, "Front panel".)
4-2 Notices on handling drivers
The drivers are electronic devices. Handle them with care and take the following precautions.
Do not connect the driver to any power supply the voltage of which differs from
the value specified on the nameplate.
If the driver is connected to any power supply the voltage of which differs from the value
specified on the nameplate, it may break, resulting in injury or fire.
100
:
Single-phase, AC 100V
(1) Because the case is made of plastic, do not apply excess force or shock.
(2) The vibration resistance of the driver is 4.9m/s
2
(10 to 55Hz). Do not mount
or transport the HS-360 driver in a manner where it would be subjected to high
levels of vibration.
(3) Do not put the HS-360 driver on the place from where it can easily fall down.
(4) Do not put anything on the driver. The case of the driver may break.
(5) The allowable storage temperature is from -20
C to +85
C. Do not expose it
to sunlight for long periods of time, and do not store it in areas where
temperatures are likely to fluctuate greatly.
(6) The allowable storage relative humidity is less than 90%. Do not store it in
highly humid place or in areas where temperatures are likely to fluctuate
greatly.
(7) Do not store the driver in areas where in corrosive gas or particles may be
present
(8) When the driver is to be powered on again after the driver input power is
turned off, do this after a lapse of 30s or more. It takes longer time to complete
the startup due to the residual charge.
Caution
Warning
(1) Do not drop screws, solder balls, wire chips, or any other foreign objects
through the ventilation gaps of the driver. Failure to observe this caution may
result in electric shock or personal injury.
(2) Do not insert electric wire, steel wire, or a screwdriver through the
ventilation gaps of the driver Failure to observe this caution may result in
electric shock or personal injury.
Warning