Harmar Mobility VPL400-X, Installation & Service Manual

Page: 25 / 40

VPL400-X:
Install Manual
21JULY2023 | 630-00159 B
25
INSTALLATION
VPL400-X: SECTION 4
OPERATIONAL CHECK
Upon installation and at scheduled intervals the
operation of the VPL must be verified.

Apply power.

Paddle/buttons on cab controls control UP
and DOWN travel.

E-Stop PRESSED IN stops and prevents travel
of platform. Button illuminates and alarm
sounds (if equipped).

Key switch (if equipped) OFF stops and
prevents travel.

Landing switches stop the platform at each
landing within 1/2", does not coast, and
opens the gate locks.

Open doors/gates prevent any travel of the
platform. If not, check the platform gate
cable is plugged into the trailing cable and
the red wire is cut/removed on the Lower
Landing Jumper Connector.

Call Station buttons control UP and DOWN
travel.

Key switch (if equipped) OFF on Call Stations
stops and prevents travel from Call Station.

Safety pan switches depressed prevent
DOWN travel and allows UP travel (check
several locations).

Pit switch (if equipped) prevents UP and
DOWN travel.