© 2018Harmar Mobility, LLC • All Rights Reserved
| www.harmar.com
8
Pinnacle SL300
INSTALLATION PROCEDURES
D. FINAL RAIL INSTALLATION
1. Install the remaining plastic rack pieces in the
upper rail.
[Figure 8-1]
2. Use a hacksaw or chop saw to cut the last plastic
rack piece flush with the rail end. Place something
on the floor to catch debris or mark and cut the
rack outside.
[Figure 8-2]
The exposed, cut end of the plastic rack should be
facing the top end of the rail (the factory-cut side
should butt against the lower rack).
3. Slide the top limit cam into one of the cam slots
(it doesn’t matter which side), and tighten the
pre-inserted Allen screw with a 5/64" Allen wrench.
This will be used to set the final upper limits for the
stair lift
[Figure 8-3
].
4. Remove charging strip from the rail box.
Connect charging strip connector to the power
wire that runs through the center of the rail from
the lower charging strips.
[Figure 8-4]
Insert the two (2) charger strips into the keyed slots
at the top of the rail (while standing on the top
landing looking down). The charging strip with the
red wire should be inserted into the left slot with
the metal strip facing out. The charging strip with
the black wire should be inserted into the right slot
with the metal strip pointing out.
[Figure 8-4]
Bend the red and black wire tabs in toward the
center of the track.
Insert excess cable into the rail, leaving the pigtail
with the Molex connector on the outside.
Figure 8-4
Figure 8-3
Figure 8-2
Figure 8-1
