© 2018Harmar Mobility, LLC • All Rights Reserved
| www.harmar.com
18
Pinnacle SL300
FOLDING RAIL INSTALLATION
7. Fasten down the near corner of the lower
bracket using a drill that has extensions at least
10
"
long and a 3/8
"
socket.
[Figure 18-1 & 18-2]
8. Measure from the side of the rail at the upper
bracket of the folding rail.
Set this at 3
"
or more. Screw down one corner of
the bracket.
9. Join to upper rail, following regular procedures
(this procedure is detailed on page 5). This
procedure includes plugging the battery charging
wire harness for the folding rail into the charging
harness from the upper rail. The power supply
itself can be plugged into either the top rail (for
the top of the stairs), or to the charge plug from
the folding rail, which comes out just higher than
the folding mechanism for the bottom of the
stairway.
10. Fasten down the other screws of both rail
brackets using the power drill and long extension
with the 3/8
"
socket.
[Figure 18-3]
Figure 18-3
Figure 18-2
Figure 18-1
Figure 18-4
11. Adjust the height of the two feet using a 9/16
"
open end wrench. Set them so that both rest on
the floor with the rail fully straight. The foot farther
from the wall should be set a little taller than the
inside one to get it to seat flat on the floor, since
the Pinnacle rail brackets intentionally lean the rail
toward the wall just a little.
[Figure 18-4]
