2
| www.harmar.com | 800-833-0478
TEC0029 2016SEPT12 PN: 630-00001 REV C
Contents
NOTE:
The following symbols indicate areas where you should take
special care to avoid danger to individuals or property.
SPECIFICATIONS 3
PRELIMINARY CHECKS
4
Headroom ................................................4
Tools Required ........................................4
Included Parts .........................................4
INSTALLATION PROCEEDURES 5
Installation ..........................................5-13
Free Standing Post Install ............10-13
REMOTE CALL/SEND CONTROLS 14
COMPLETION PROCEDURES 15
WARNING
Hazardous situation. If not avoided,
could result in serious injury to
installer or user.
CAUTION!
Hazardous situation. If not
avoided, could result in serious
damage to property.
The Sierra Inclined Platform Lift is designed to
transport a user and their manual wheelchair up
or down a straight stairway.
This manual provides instructions for properly
installating this Inclined Platform Lift.
Please refer to the Owner’s Manual for operating
instructions. Be sure to give the Owner’s Manual to
the lift's owner before it is put into service.
Any alterations to the equipment without written
authorization by the manufacturer
may void the warranty.
Harmar lifts are designed to install with as little assembly
by the installer as possible. If you have questions,
concerns or comments, please contact Harmar’s
Technical Service Department at
1-866-378-6848
or email
NOTE: New Control Board &
Charging System On Sierra Inclined
Platform Lifts (IL500)
All Sierra Inclined Platform Lifts manufactured
since June 30, 2014 were shipped with an
improved Control design.
The new Control Board affects Sierra Inclined Platform
Lifts starting with Serial Number 400362. It replaces
the earlier model Control Board for Lifts with Serial
Number 400361 and lower.
The new Control Board and the earlier Board are NOT
compatible for direct replacement.
Charging System
A new Battery Charger is now onboard the control
board and is powered by an external 33VDC 1A Power
Supply. (Part Number 320-00004)
The 29.1 VDC power supply (Part #320-00004) has
a green LED that only indicates that the supply is
connected to household current.
IR Remotes and Receivers:
Compatible and
interchangeable with the new and old control boards.
FOR ADDITIONAL INFORMATION:
Please call Harmar Technical Support: 866-378-6648.
CAUTION
This new Power Supply is NOT a
replacement for the older
battery charger.
“Indications of Use Statement”
The Sierra inclined platform lift is to assist transfer of
patient or mobility impaired person up and down a
straight stairway in their manual wheelchair..
