Harmar Mobility AL010, Installation & Service Manual

Page: 25 / 36

Outside Vehicle Lifts: Installation & Service Manual
06DEC19 | P/N: 630-00106 REV A
25
OUTSIDE VEHICLE LIFTS: SECTION 6
LIFT ADJUSTMENTS
Figure 6-14
This method allows the T-handle to remain on the
same side as the key and toggle switches. If you wish
to have the T-handle on the opposite side as the key
and toggle switches, you can flip the entire assembly.
Verify that the hold-down arm produces enough
pressure on the seat to hold the power chair firmly
on the platform. The seat should be somewhat
indented by the arm. See Figure 6-15.
NOTICE
Figure 6-15
AL580-HDX
The AL580-HDX is built to accommodate most of the
complex mid-wheel power chairs produced by major
manufacturers. The wheel cradles are preset for the
Quantum Edge 2.0 and Edge 3.0 Power Bases. However,
suspensions can change the overall ground clearance
and some options change the center of gravity.
Every installation must be checked and validated
to ensure that as much of the wheel is captured
before the wheelchair frame makes contact with the
platform.
The AL580-HDX platform will capture the mid-drive
wheels in adjustable gaps and will rest the chair’s
battery tray on the platform pad. See Figure 6-16.
Figure 6-16
1. Position the chair on the platform. Stop when
the drive wheels are in the platform gaps. Raise
the platform off the ground and inspect the
chair. See Figure 6-17.
Higher or lower arm settings can
be achieved by removing the top
shaft collar, retracting T-handle,
and re-inserting arm from above
or below.
Replace Shaft Collar
GAP
GAP
PAD
GAP
GAP
PAD
Having the customer’s power chair present with all
its adjustments and options installed is required. It
is recommended the lift be installed in the vehicle’s
hitch, and wired with power before proceeding.
NOTICE