Harman® • XXV Installation Manual_R23 • 2004 -___ • 08/13
2 0
3-90-00684i
5
Appliance Set-Up
Figure 5.1
A. Unpacking
The XXV is attached to the skid support with 4 - 1/4-20 X
5/8” Hex C/S Screws to prevent movement during shipping.
To free the stove from the skid support you must remove the
(4) 1/4-20 x 5/8” screws located within the support. Figure
5.1. (2) 1/4-20 x 5/8” are located just inside the door under
the ash pan. (2) 1/4-20 x 5/8” are locate at the back of the
unit behind the rear cover panels. See section B.
NOTE: There is a support located under the unit bolted
to the skid that does NOT need to be removed.
B. Removing Rear Cover Panels
The rear cover panels are secured to the stove with two
screws each. These screws need only be loosened, not
removed, to remove the panels. It is recommended that the
rear covers are installed after the unit is in place and the vent
pipe is installed, to prevent contact with hot or moving parts.
C. Flame Guide
Install the cast iron flame guide on top of the burn pot. Make
sure that the flame guide is fully seated on the vertical sides
of the burn pot and that the back of the guide rests against
the body of the stove. Figure 5.3.
INSTALL EXHAUST VENT AT CLEARANCES SPECIFIED
BY THE MANUFACTURER. Most pellet vent pipe requires a
minimum of 3" of clearance to combustible materials although
some can be installed at 1" clearance.
Follow these instructions along with all local codes regarding
installation of this appliance.
D o
NOT
use makeshift compromises when installing this
appliance, serious consequences may result.
With any hearth appliance, installation of smoke detectors
is recommended on every level of the home.
Possible causes of smoke detector activation:
Paint curing process - Open a window near the appliance
for the first few hours of burning.
Exhaust being drawn back inside the dwelling - Outside air
connection to the appliance is necessary.
Vent leakage - All interior seams and joints should be sealed
with silicone where applicable. Follow vent manufacturers
instructions for proper sealing.
Figure 5.2
Figure 5.3
Flame guide
(4) 1/4-20 x 5/8” Hex Screws
Skid Support
(2) 1/4-20 x 5/8” Hex Screws
