Harman Martin MAC Ultra Wash, User Manual

Page: 32 / 35

32
MAC Ultra Wash User Guide
*High temperature warnings are canceled as soon as temperature returns to normal. If temperature reaches
cutoff level, the warning is replaced by a cutoff error message.
Error messages
Error messages indicate that a problem is present. The MAC Ultra Wash communicates errors as follows:
• Error messages flash in the display.
• If more than one error is detected, the fixture flashes all errors three times each.
• Errors are shown in the display regardless of display status: they override an inactive display and any
other information that the display might be showing.
• If an error is present, the status LED flashes red.
The possible error messages are listed in Table 4 below
:
SERV
SERVICE MODE
Fixture in service mode.
TLTW
TILT TEMP HIGH
Tilt motor sensor detects abnormally high operating temperature.*
UITW
UI TEMP HIGH
User interface (LCD display and control panel) PCB sensor detects abnormally high operating
temperature.*
ZFTW
ZF TEMP HIGH
Zoom/focus PCB sensor detects abnormally high operating temperature.*
Short code
Long message and explanation
BETC
BM TMP CUT OFF
LED beam pixels temperature cutoff activated.
BETE
BM TMP SEN ERR
LED beam pixels temperature sensor error.
C1ER
COLORWHEEL 1 ERR
Color Wheel error.
CECM
COM ERR CMY
CMY module communication error.
CEEF
COM ERR EFFECT
Effects module communication error.
CELD
COM ERR LED DRV
LED driver communication error.
CEPN
COM ERR PAN
Pan system communication error.
CETL
COM ERR TILT
Tilt system communication error.
CEZF
COM ERR Z/F
Zoom/focus effect communication error.
CMCT
CMY TEMP CUTOFF
CMY module temperature cutoff activated.
CMTE
CMY TEMP SEN ERR
CMY module temperature sensor error.
COLD
FIXTURE COLD
Fixture too cold. Physical movement of effects is disabled until fixture has warmed up.
CTER
CTC ERROR
CTC flag position error.
Table 4: Error messages
Short code
Long message and explanation
Table 3: Warning messages