Harman Martin MAC Ultra Performance, User Manual

Page: 34 / 41

34
MAC Ultra Performance User Guide
TEST*
TEST ALL DIMMER ... TILT
Run test sequence of all functions
To test a specific function, use Up/Down
buttons to scroll through functions. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
TEST LEDS DIMMER
Run test sequence of LEDs only.
Press Menu button to exit test
TEST EFFECTS CMY ... FOCUS
Run test sequence of effects.
To test a specific effect, use Up/Down
buttons to scroll through groups. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
TEST PAN/TILT
PAN
Run test sequence of pan functions.
Press Menu button to exit test
TILT
Run test sequence of tilt functions.
Press Menu button to exit test
MANUAL
CONTROL*
RESET
ALL Reset fixture
STROBE ... FX SYNC
Scroll through effects, then manually
control an effect
FX 1 0-255 Select FX 1, then enter a value from 0 to
255 (one channel) or 0 to 65535 (two DMX
channels: 256 x 256) to apply a command
FX 1 ADJUST 0-255
FX 2 0-255 Select FX 2, then enter a value from 0 to
255 (one channel) or 0 to 65535 (two DMX
channels: 256 x 256) to apply a command
FX 2 ADJUST 0-255
FX SYNC 0-255
Select FX SYNC, then enter a value from 0
to 255 to manually adjust FX
synchronization
SERVICE*
(see “Activating
service mode” on
page 13)
ERROR LIST Empty or up to 20 errors
Show all error and warning messages
stored in memory.
FAN CLEAN ON/ OFF
Run cooling fans at high speed to dislodge
dust and debris.
PAN/TILT
FEEDBACK
ON
Enable pan/tilt position feedback
system
OFF Disable pan/tilt position feedback system
ADJUST
(for use by or with
guidance from
Martin Service
only)
PAN/TILT AT END
STOP
STEP 1
To adjust, move head to end position and
press ENTER
STEP 2
To adjust, move head to end position again
and press ENTER
CALIBRATION
DIMMER
...
TILT Calibration range
varies depending
on effect Scroll through effects, press Enter to
select. Adjust position and press Enter to
confirm.
LOAD DEFAULTS LOAD Load factory default calibration settings
SAVE DEFAULTS SAVE
Replace factory default calibration settings
with current calibration settings
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 2: Control menus