Harman Martin ELP WW, User Manual, Page: 16 / 36

16 Martin® ELP WW User Manual
To set the fixture’s dimmer curve, select DIMMER CURVE from the PERSONALITY menu and
press ENTER to confirm. Use the UP and DOWN buttons to select the desired mode. Press
ENTER to save your selection.
PWM Frequency
Sets the frequency of the PWM dimming used on the fixture. It can sometimes be necessary to
change this if flickering is seen on TV cameras running at a high shutter speed.
From firmware v.1.2, the PWM frequency settings available range from 600 Hz to 2400 Hz. The
default frequency is 1200 Hz.
No Data Mode
This option sets what will happen when no DMX data is present.
To set No Data Mode, select NO DATA MODE from the PERSONALITY menu and press ENTER
to confirm. Use the UP and DOWN buttons to select:
•
BLACKOUT – If data connection is lost, fixture blacks out.
•
HOLD – If data connection is lost, fixture obeys the last DMX commands received on all
channels (default).
Press ENTER to confirm.
Cooling Mode
This option sets whether cooling fan speed is regulated depending on fixture temperature or
whether the cooling fans run at a constant speed.
To set cooling mode, select COOLING MODE from the PERSONALITY menu and press ENTER
to confirm. Use the UP and DOWN buttons to select:
•
REGULATED FANS – Fan speed is controlled by fixture temperature. Fans only run at the
speed necessary to keep the fixture within its normal operating temperature range. Light
output is not reduced unless full fan speed is not enough to keep the fixture within its safe
operating temperature range.
•
FULL – Fans are set to constant full speed. Light output is not reduced unless full fan speed is
not enough to keep the fixture within its safe operating temperature range.
•
LOW – Fans are set to constant low speed. The maximum light output available is reduced by
approx. 15% and fan noise is significantly reduced.
Press ENTER to confirm.
Display
This option allows you to set some parameters for the display screen.
Select DISPLAY from the PERSONALITY menu and press ENTER to confirm.
Use the UP and DOWN buttons to select:
•
DISPLAY SLEEP – Use the UP and DOWN buttons to select display sleep time, settings
are ON (Display permanently on), 2 MINUTES, 5 MINUTES or 10 MINUTES
•
DISPLAY ROTATION –Use the UP and DOWN buttons to select Normal (Display
orientation normal) or ROTATE 180 (Display orientation rotated 180°)
•
DISPLAY INTENSITY –Use the UP and DOWN buttons to adjust display intensity from
10%-100% (default = 100%)
•
TEMPERATURE UNIT – Use the UP and DOWN buttons to select °C or °F
Press ENTER to confirm.
Set all settings to factory default
To return all settings to factory default, select DEFAULT SETTINGS and press ENTER to confirm,
FACTORY DEFAULT will show on the display. Press ENTER again.
Use the UP and DOWN buttons to select NO (cancel) or YES (return all settings except
calibrations to factory defaults).