5
Installation
Mounting the BLU-USB
The BLU-USB comes equipped with rubber feet to prevent it from sliding when
placed on a desktop or other surface. The BLU-USB can also be mounted to a
surface (e.g., wall, desk, conference table, etc.) using the included mounting
brackets.
To mount the BLU-USB:
1.
Mount the included brackets to the side of the BLU-USB chassis using the
four included fine-threaded screws.
2.
Mount the BLU-USB to the surface using the four included coarse-
threaded screws and washers.
Mounting Surface
NOTE:
For best results, pre-drill the holes in the mounting surface. This
can be accomplished by measuring then marking the hole locations, or
by placing the BLU-USB in the mounting position then marking the hole
locations. Make sure to use a drill bit which is slightly smaller in diameter
than the included mounting screws.
