Decoder Configuration Options
43
N2312/N2322 User Manual
HDMI Off On Stream
Loss
Select to disable the video output drive when the video
stream is not available.
HDMI Enable
Select to enable output video.
Gratuitous ARP
Enable the Decoder to send a periodic Address
Resolution Protocol (ARP) packet to the network.
ARP Interval (secs)
Determine how often (in seconds) the unit transmits
gratuitous ARP packets.
Unsolicited Status
Enable the Decoder to send a periodic status packet to
the
Send Status Address
described below.
Send Status Address
When
Unsolicited Status
is enabled, the Decoder sends
a periodic status packet to the IP address specified
here.
Status Interval (secs)
Determine how often (in seconds) the unit transmits
status packets.
Serial Master Enable
Enable this device to be the master to the
designated
client
.
Serial
Client
Address
Enter the IP address of the serial
client
device.
IR Command Holdoff
Set the delay between IR command portions. The
default setting is 25 ms.
IR commands are sent in two parts. This setting is the
time (in milliseconds) between transmission of part
one and part two. The second part of the command is
inverted for confirmation purposes.
IR Repeat Holdoff
Set the repeat delay between IR commands. The default
setting is 90 ms.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
IGMP Joins on Stream
Loss
Enable to send Internet Group Management Protocol
(IGMP) join messages when no incoming stream is
detected.
IGMP Join Interval
Delay in seconds between sending IGMP join messages
(if
IGMP Joins on Stream Loss
is enabled).
Save button
Click to save settings made in this portion of the
Advanced
section.
Enable SNMP
Enable to allow the device to send Simple Network
Management Protocol (SNMP) packets.
Interleaved Multicast
Streams
Enables a multicast format which interleaves video and
audio streams.
In order for N-Series devices to communicate with
each other, their multicast settings must be
compatible.
Discovery Packet
Transmit
Enable the N-Series multicast discovery service (which
is used to identify units).
This is useful for larger network integrations when
broadcast packets will not cover the entire network.
Enabled by default.
Discovery Interval
(secs)
Determine how often (in seconds) the unit transmits
discovery packets.
KVM Enable
Enable to allow the ability to share mouse and keyboard
over the network. Disabled by default. When disabled,
the unit works like a non-KVM unit and ignores any
keyboard or mouse activity.
KVM IP
View/edit the IP address of the KVM Encoder currently
connected to this Decoder.
IR Passthrough Enable
Enables support for passing IR input data from one unit
to the IR output on another.
This must be enabled on both the sender and
receiver.
IR Client IP
Specifies the IP address of the unit to send IR
passthrough data to.
Netlinx Enable
Click to enable/disable NetLinx support on this device.
RS232 Settings
Set the baud rate, data bits, parity, and stop bit for the
RS232 serial interface.
TABLE 14
Settings Page: Advanced Settings (Cont.)
Option
Description
Notes
