HARDWARE MANUAL – DX-TX-DWP-4K60 | 10
Installation and Wiring
Mounting Options for Wallplate
The DXLink 4K60 HDMI wallplate transmitter mounts in a standard US single gang back box. Standard
decora style cover plates are provided to allow matching the individual decor of an environment or
matching other standard decor covers in a room/area.
IMPORTANT: Be sure to measure the back box and any other components used to mount the Wallplate
prior to installation/construction to ensure the unit fits (e.g., some mud rings do not work unless their
corners are modified).
Wiring
Warnings:
Before wiring, disconnect the power from all devices.
Before wiring, please see “
” section to do the corresponding configurations.
When connecting with a DGX switcher, power requirements must be determined. (See “
” of
“Installation and Wiring” section).
During wiring, connect and disconnect the cables gently.
Steps for Device Wiring
a)
Extender Mode (Standalone)
A Transmitter and Receiver standalone pair can work together as an extender solution for
transmission of HDMI over twisted pair cable.
1.
Connect a high-quality category cable to DXLINK ports between transmitter and receiver (DX-
RX-4K60 or DXL-RX-4K60).
2.
Connect an HDMI source (such as PC) to the HDMI IN port of the transmitter with a high-
quality HDMI cable.
3.
Connect HDMI display (such as TV or projector) to the HDMI OUT port of receiver.
4.
For additional control options:
USB Control: Connect a USB Host PC to the USB HOST port of the transmitter and connect a
USB device (such as a keyboard or mouse) to USB port of the receiver. The USB device can
be connected to the host PC.
RS-232 Pass-Through: Set the RS-232 switch of the transmitter to “PASS THROUGH”.
Connect a RS-232 host (or client) device to RS-232 port of the transmitter, and a client (or
host) device to RS-232 port of the receiver. The RS-232 serial signal will be passed through
bi-directionally.
5.
Connect the transmitter and the receiver with the power adapters.
