Harman AMX CTP-1301, User Manual

Page: 27 / 60

User Manual - CTP-1301 26
Display
Auto Display Control allows control of CEC-enabled displays connected to the CTP-1301 through HDMI.
• ON: Click to enable the Auto Display Control.
• OFF: Click to disable the Auto Display Control. (Default setting)
• DELAY TIME (1~30 min): Click the down arrow to set the time for the display to power off automatically when no signal is
present. Example: With the time set to 2 minutes, the output display will be powered off automatically when there is no signal
input for 2 minutes.
Note: The time range for Auto Display Control is 1-30 minutes.
RS232 Setting allows RS232 configuration for controlling a third-party device or passing though RS232 commands.
• Control:
1) Local : Select to perform control on the third-party device connected. (Default setting)
2) NetLinx : Select to perform RS232 command pass-through through NetLinx Studio.
• Device : When “NetLinx” is selected, click the down arrow to select TX or RX for RS232 configuration.
• Baud Rate
: Click the down arrow to select the baud rate.
• Parity Bits : Click the down arrow to select the parity bits.
• Data Bits : Click the down arrow to select the data bits.
• Stop Bits : Click the down arrow to select the stop bits.
• END FLAG : Select the ending flag for each RS232 command.
• POWER ON : Enter the RS232 command for powering the display on.
• POWER OFF : Enter the RS232 command for powering the display off.
• SAVE : Click to save the setting changes.