Harman® • Accentra 52i Owner’s Manual_R8 • 2013 -___ • 07/14
10
3-90-00574c
Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the fire protection and venting
instructions.
2. Double check that the ash pan and firebox are empty!
3. Close the front door.
Fire Hazard
Keep combustible materials, gasoline and
other flammable vapors and liquids clear
of appliance.
E. General Operating Information
Room Sensor
The appliance is like most modern furnaces; when the room
sensor calls for heat, your appliance will
automatically light
and deliver heat.
When the room is up to temperature and the room sensor is
satisfied, the appliance will shut down.
Heat Output Controls
The appliance will turn on and off as the room sensor
demands. When the room sensor calls for heat, the appliance
will always start up on High. After burning approximately 7-10
minutes, the appliance will then burn at the rate at which it
was originally set. If the appliance is set at one of the lower
settings, it will run quieter but take longer to heat up an area
than if it were set at a higher burn rate.
Regardless of the burn rate, when the area is warm enough
to satisfy the room sensor, the appliance will shut off.
WARNING
!
• Do NOT store flammable materials in the appliance’s
vicinity.
• NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID,
OR SIMILAR LIQUIDS TO START OR “FRESHEN
UP” A FIRE IN THIS HEATER. KEEP ALL SUCH
LIQUIDS WELL AWAY FROM THE HEATER WHILE
IT IS IN USE
.
• DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL.
• DO NOT USE CHEMICALS OF FLUIDS TO START
THE FIRE.
• Combustible materials may ignite.
Figure 3.1
