Accentra 52i Pellet Insert Zero Clearance Cabinet
Part #1-00-574323
2
Contents of Kit;
Cabinet components-
1- Top Panel
1- Bottom Panel
2- Side Panels
1- Rear Panel
32- #10 X 3/4” Tek Screws (Self-Tapping)
4- 1/4-20 x 5/8 Thread Cutters
Tools Needed;
Cordless Drill or Screw gun
5/16” Driver Bit
3/8” Driver Bit
CAUTION! Use care when installing Tek screws,
do not strip the holes.
• Begin with the bottom panel lying flat on the floor or
workbench. Place it with the writing facing upward
as shown.
• Stand a side panel up to the right or left side of the
bottom. Notice the bend at the rear of the cabinet
will make the corner and at the front it will be bent
outward to make the facing flange. Line up the
holes and secure the side panel to the bottom with
(3) Tek screws. Repeat for the opposite side. Figure
1.
NOTE: Only install 3 Tek screws.
• The top panel can now be put into place, with the
bend going out over the side panels. Align the holes
and secure with (6) Tek screws. Figure 2.
• Stand the rear panel up to the rear of the cabinet
making sure the holes on the edge of the panel
line up with the holes from the side panels and top.
Secure the rear panel to the outside of the cabinet
using the remaining (20) Tek screws. Figure 3.
Figure 1
Figure 2
Figure 3
1/4-20 x 5/8
Thread Cutters
