Harman 300i Wood Insert
18
For Installation In Masonry Fireplace Only
Installation
When installing the insert, you'll need to connect the
flue liner to the insert collar with a minimum of three
fasteners. The flue adapter is removable for ease of
installation in tighter fireplaces.
Remove the flue collar from the insert by loosening
the two bolts in the top. Attach the flue collar to the liner
using three sheetmetal screws. There are two lines
etched into the top of the flue collar bracket. These lines
should line up with the front of the fireplace opening.
Keep the height of the bracket at approximately 24"
from the floor. While sliding the insert into the firplace,
guide the flue collar bracket onto the top of the insert.
The bracket will pull itself into position as the stove
body comes back. The bend on the front of the flue
bracket, and the hooks on the rear will secure the flue
collar tightly to the insert. When the flue is in its proper
position, install the two bolts down through the bracket
to secure it.
handle Installation
The door latch handle and the damper handle are
left off for shipping, and will need to be installed. Both
handles and their bolts are packaged in the hardware
bag. The shorter bolt (2-1/4") will be used for the
damper handle, and the longer bolt (2-1/2") is for the
door handle. Insert the bolt through the open end of the
handle, then thread the bolt into the latch or the damper
drive arm. Tighten only hand tight to prevent cracking
of the wooden knob.
holes are provided
for securing pipe
with a minimum of
three (3) fasteners
This bend on the
front will hold down
on the collar when in
place under the lip.
The hooks on back
will hold down on the
collar when in place.
Two bolts secure the
flue adapter to the
insert.
Etched lines mark
the face of the
fireplace opening.
Summary of Contents for 300i
Page 2: ......