4
Introduction
The Harman Clarity 828
I
Vented Gas Fireplace
Insert is a listed gas-fired vented room heater
tested by Intertek Testing Services/Warnock
Hersey to ANSI standard Z21.88-2002, CSA2.33-
M02, and CAN/CGA-2.17-M91.
The installation of the Clarity Fireplace Insert
must conform with local codes, or in the absence
of local codes, with National Fuel Gas Code, ANSI
Z223.1 — latest edition (NFPA 54) and CAN 1 B1-
149.1 and .2 Gas Appliance Installation Code.
Installer l'appareil selon les codes ou règlements
locaux, ou, en l'absence de tels règlements, selon
les Codes d'installation CAN/CGA-B149.
The Clarity Fireplace Insert is not for use in
mobile homes.
CAUTION: This appliance must be vented to
the outside.
INSTALLATION AND REPAIR OF THE CLAR-
ITY FIREPLACE INSERT SHOULD BE DONE BY
A QUALIFIED SERVICE PERSON. THE APPLI-
ANCE SHOULD BE INSPECTED BEFORE USE
AND AT LEAST ANNUALLY BY A QUALIFIED
SERVICE PERSON. MORE FREQUENT CLEAN-
ING MAY BE REQUIRED DUE TO EXCESSIVE
LINT FROM CARPETING, BEDDING MATE-
RIAL, ETC. IT IS IMPERATIVE THAT CONTROL
COMPARTMENTS, BURNERS, AND CIRCU-
LATING AIR PASSAGEWAYS OF THE APPLI-
ANCE BE KEPT CLEAN. ANY SAFETY SCREEN
OR GUARD REMOVED FOR SERVICING AN
APPLIANCE MUST BE REPLACED PRIOR TO
OPERATING THE APPLIANCE.
S 'ASS URER QUE LE BRÛLEUR ET LE
COMPARTIMENT DES COMMANDES SONT
PROPRES . VOI R LES I NS TRUC TI ON S
D'I NS TALLATI ON ET D'UTI LI SATI ON QUI
ACCOMPAGNENT L'APPAREIL.
When operating your Harman Clarity Fireplace
Insert, respect basic safety standards.
Read these instructions carefully before you at-
tempt to operate the heater. Failure to do so may
result in damage to property or personal injury
and may void the product warranty.
Consult with your local building code agency
and insurance representative before you begin
your installation to ensure compliance with local
codes, including the need for permits and follow-
up inspections.
Observing required clearances to combustible
materials, proper connection to an approved vent-
ing system, and the accessibility of the gas and
electrical supply must all be considered when
planning the installation of an Clarity Fireplace
Insert.
Adequate clearances around air openings to the
combustion chamber and provisions for adequate
combustion and ventilation air must be provided.
Install the Clarity Fireplace Insert only in a listed
solid-fuel burning factory-built fireplace or a ma-
sonry solid-fuel burning fireplace. The Fireplace
Insert and vent should be enclosed when installed
in, or when passing through, a living area where
children may come in contact with it.
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.