5
OPERATION
Operation
HOW TO LIGHT THE FIRE
1. STOP! Read the safety information on the
front cover of this manual.
2. If using the optional thermostat, set thermostat
to the lowest setting.
3. Turn off electric power to the optional blower.
4. Turn the ON-OFF switch to the OFF position.
5. Push in the gas control knob slightly and turn it
clockwise to "OFF." NOTE: THE KNOB
CANNOT BE TURNED FROM "PILOT" TO
"OFF" UNLESS IT IS PUSHED IN SLIGHTLY.
DO NOT FORCE IT.
6. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow "B" in the
safety information on the front cover. If you
don't smell gas, go to the next step.
7. Set the High-Low Regulator to High by turning
it fully counterclockwise.
8. Press in the gas control knob slightly and turn
counterclockwise to "PILOT."
9. Find the pilot by looking down between the
logs as shown at lower left.
10. Push the control knob fully down and hold.
Immediately push the red piezo ignitor button to
light the pilot. It is normal to have to push the
red button several times before the pilot ignites.
Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release the
knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 5
through 10.
•If the knob does not pop up when re-
leased, stop and immediately call your service
technician or gas supplier.
•If the pilot will not stay lit after several
tries, turn the gas control knob to "OFF" and
call your service technician or gas supplier.
11. Turn the gas control knob counterclockwise to
"ON."
12. Place the ON-OFF switch in the ON position
or turn up the thermostat setting if the optional
thermostat is used.
13. Turn on the electric power to the optional
blower if installed.
14. Set the optional thermostat to the desired
room temperature.
Piezo Ignitor
Button
PILOT
Gas Control
High-Low
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.
