Harman Kardon BDP 1/120, Service Manual

Page: 21 / 54

Software upgrade
Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc)
2) Burn the oppointed data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will display :
Files coping…
UPGRADING…
4) The upgraded tray will automatically open when files
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
B. Read out the software versions to confirm upgrading
1) Power on the set and press <Setup> button on the
remote control.
The software version and other information are displayed
on the TV screen as follows:
4-1
Caution: The set
MUST NOT
be power
ed
off
during upgrading, otherwise the Main
B
oard
will be
irreparably
damaged.
* The other upgrade SW way is by memory, the steps are the
same as CDR's, create the upgrade file into memory, and
connect the USB flash drive to the USB socket on set, then
press "USB" on remote control to access the content and
play the upgrade file as above upgrade procedure.
*
2) Then press down cursor on the remote control to choose
"System" , and press the right cursor on the remote control
to choose "software version".
6) Restart the set after above steps;
Remark: If the upgraded software
shows an error message:
A
.
S
ame version:
U
pgrade software twice
.
B
.
D
ifferent version:
U
pgrade
the
software
versions one after
the
other
, and make
sure to upgrade the current version first.
Version information
CFE Version:X.XX.XX
APP Version:BDP_XX_VX.XX
LOADER Version:XXXX
FP MCU Version:HarmanXX_XXX
21
harman/kardon BDP 1 / BDP 10 Service Manual