Harman Kardon BDP 1/120, Service Manual

Page: 18 / 54

16
INSTALLATION
Figure 6 – Remote IR Input and Output
Step Six – Network Connection
Connect the Network Jack to a router or Ethernet-compatible
controller. See Figure 7. The network connection is used for BD-Live
discs to access the Internet for updates to the disc content and special
features.
Figure 7 – Network Jack
Step Seven – Plug In AC Power
To avoid possible damage from a transient power surge at plug-in,
TURNOFFTHE-ASTER0OWER3WITCH0LUGTHEFEMALEENDOFTHE!#
Power cord into the receptacle (see Figure 8), and the male end into
an unswitched AC outlet.
&IGUREn-ASTER0OWER3WITCHAND!#0OWER)NPUT
Step Eight – Insert Batteries in Remote
The BDP 10 remote control uses two AA batteries (included).
To remove the battery cover located on the back of the remote, lift
the tab until the latch releases, and lift the battery cover up. Insert the
batteries as shown in Figure 9, observing the correct polarity.
To replace the cover, insert the two small tabs at the top of the cover
into the recesses at the top of the battery compartment, and lower the
cover, pressing the latch at the bottom until it snaps shut.
Figure 9 – Remote Battery Compartment
Point the remote toward the front panel of the BDP 10. The IR receiver
ISLOCATEDIMMEDIATELYTOTHERIGHTOFTHE-ESSAGE$ISPLAY-AKESURE
no objects are blocking the remote’s path. Bright lights, fluorescent
lights and plasma video displays may interfere with the remote’s
functioning. The remote has a range of about 6 m, depending on the
lighting conditions. It may be used at an angle of up to 30 degrees to
either side of the BDP 10.
If the remote seems to operate intermittently, make sure the batteries
have been inserted correctly, or replace both batteries with fresh ones.
for BDP10
for BDP10
18
harman/kardon BDP 1 / BDP 10 Service Manual