PROGRAMMING THE REMOTE
47
Programming the Remote
Resetting the Remote Memory
As you add components to your home-theater sys-
tem, occasionally you may wish to totally repro-
gram the remote control without the confusion of
any commands, macros or ”Punch-Through“ pro-
gramming that you may have done. To do this, it is
possible to reset the remote to the original factory
defaults and command codes by following these
steps. Note, however, that once the remote is
reset, all commands or codes that you have
entered will be erased and will need to be re-
entered:
1. Press any of the
Input Selector
buttons
4
and the
”O“
button
H
at the same time until
the
Program/SPL Indicator
2
begins to flash
amber.
2. Press the
”3“
button
H
three times.
3. The red LED under the
Input Selector
4
will
go out and the
Program/SPL Indicator
2
will
stop flashing and turn green.
4. The
Program/SPL Indicator
2
will remain
green until the remote is reset. Note that this may
take a while, depending on how many commands
are in the memory and need to be erased.
5. When the
Program/SPL Indicator
2
goes
out, the remote has been reset to the factory set-
tings.
