5
PC 45 Corn/Pellet Stove
Fig. 4
Fig. 5
18"
Fig. 3
Fig. 6: Refer to page
17 for detailed draft
settings and adjustment
procedures.
9"-13"
9"-13"
9" With Side Shields
13" Without Side Shields
Installation
When installing this unit in a mobile home several requirements must be
followed:
1. The unit must be bolted to the floor. This can be done with 1/4"
lag screws through the 2 holes in the base plate.
2. The unit must also be connected to outside air. See page 7.
3. Floor protection and clearances must be followed as shown.
4. Unit must be grounded to the metal frame of the mobile home.
5. Do not Install in a room designated for sleeping.
6. The structural integrity of the mobile home floor, walls, and ceiling/ roof
must be maintained.
CAuTION: This appliance must be vented to the outside.
Due to high temperatures, the stove should be placed out of traffic and away from
furniture and draperies.
Children and adults should be alerted to the hazards of high surface tem-
peratures and should stay away to avoid burn to skin and/or clothing.
Young children should be carefully supervised when they are in the same
room as the stove.
Clothing and other flammable materials should not be placed on or near
this unit.
Installation and repair of this Harman Stove should be done by a quali-
fied service person. The appliance should be inspected before use and at
least annually by a qualified service person. More frequent cleaning will be
required. It is imperative that control compartments, burners, and circulating
air passageways of the stove be kept clean.
mobile home installation should be done in accordance with the
manufactured home and Safety Standard (hud), CFr 3280, Part 24.
location
Place the stove on a noncombustible floor or a floor protector; a
minimum of 3/8" material with .84 k value per inch. Floor protection
must extend 6 inches to the front, 6 inches to the sides and 1 inch
to the rear of the stove. Place the stove away from combustible
walls at least as far as shown in figures 3,4 & 5. Please note the
difference in side wall clearance with and without side shields.
Note that the clearances shown are minimum for safety but do
not leave much room for access when cleaning or servicing. Please
take this into account when placing the stove.
Connect the power cord to a 120 V.A.C. 60Hz grounded recep-
tacle. (A surge protector is recommened to protect the circuit board).
Prior to installing the flue pipe, connect a draft meter to the stove
as shown in fig. 6. (The draft meter must have a minimum range of
0"- 0.5"). Turn stove to "TEST" Mode and record the draft reading
______. After the flue pipe is connected, check the draft reading
again making sure all doors and windows in the home are closed.
If this reading is more than.05" higher than the unconnected read-
ing, check for possible restrictions or the need for outside air. (See
page 7).
mobile home Installation