Harley Benton HB-20MFX, User Manual

Page: 18 / 32

16 [POWER]
Mains switch. Turns the device on and off.
If the device does not receive any signal for about 25 minutes at the
[INPUT] socket, it will automatically turn to
standby mode. The LED to the left of the switch then only glows. To turn the device on again, switch it off briefly with
the [POWER] switch and then on again.
17 [CH1~4 | Panel]
The settings for VOICE, GAIN, VOLUME, TREBLE, MIDDLE, BASS, PARAM and EFX can be saved in the memory locations
CH1 ~ 4. This means that four different sounds can be called up at the touch of a button.
To save the sound set with the aforementioned controls and buttons, press and hold the button for the desired
memory location for one second. After releasing the button, it flashes briefly, indicating that saving has been suc‐
cessful. To activate the sounds stored under 1 – 4, briefly press the desired button, the LED of which then changes
from red to green.
If you change one of the parameters mentioned while using a saved sound, the LED of the active memory location
changes to red. The [PANEL] LED changes to green and shows that the sound set with the controls and buttons is
active again. You can also press [PANEL] at any time to switch to the sound set with the knobs and buttons.
Connections and controls
18
HB-20MFX | HB-40MFX
Guitar Combo