11
Flat tuning setting:
Press button
e
and
r
to move flashing cursor to position
FLAT in the above picture. Then press button
y
and
u
to
select the flat setting you need. You can set standard mode
tuning or flat tuning. Flat tuning can be set as
,
,
and
.
Flat setting will display at FLAT position in above LCD picture.
* It’s standard tuning if there is no “
” at the position FLAT in the LCD.
How to tune:
When tuning, the musical instrument gives a sound. The note
name of that sound will display at position A in the LCD. Adjust
the sound of the musical instrument to get the desired note
name in the LCD. At the same time, the needle in the LCD
will move according to the sound. When the sound is lower or
higher, the LED indicating light will light red. When the sound is
in tune, the LED indicating light
f
will light green. And at this
time the LCD needle will be at the center position.
z
Metronome mode
1. After entering this mode,
the LCD display will be as
the left picture.
2. Beat setting:
Press button
e
and
r
and
to move cursor to posi-
tion BEAT as shown in the
picture. Then press button
y
and
u
and to adjust the
beat. Beat adjusting range
is from 0 to 9. After finish
-
ing beat setting, you can move the cursor to the position you
need by pressing button
y
and
u
to set other parameter. If
you have finished setting, press button
t
to confirm.
Metronome mode LCD
* The gray parts are possibly to be displayed.
Only the black parts are displayed for certain.
