11
[POWER]
| IEC chassis plug for connecting the mains cable with fuse holder
12
[D.I.]
| balanced direct-output with MIC level for connection to a mixer, directly to a PA system or for recording
13
[SPEAKER OUT]
| speaker output (Speaker Twist) for connecting suitable speaker boxes. The overall impedance of the
connected load must not fall below 4 Ω.
14 Housing fan
15
[PRE/POST]
| this switch determines where the DI signal is tapped. In
[PRE]
position, the signal is tapped before tone
control and compressor, in
[POST]
position behind.
16
[LIFT/GND]
| this switch disconnects or connects the ground potential of the DI output and the device ground. In
[LIFT]
position (released), the device ground is disconnected. This can possibly eliminate noise caused by ground
loops, that may occur when connecting the device to other grounded equipment. In
[GND]
position (pressed), the
device ground is connected.
17 Mains switch. Turns the device on and off.
Connections and operating elements
Block-300B
17
Bass Head
Summary of Contents for Block-300B
