Harken Riggers Winch 200, Installation Manual, Page: 16 / 23

16 Riggers Winch 200 01/03/19
10. Mount winch to plate using 5 x M5
bolts. Blue Loctite (243) should be used.
NOTE. To obtain correct Maximum
Working Load (MWL), all five bolts, must
be securely tightened (8 Nm/71 in-lb) into plate.
WARNING! Failure to use correct number of mounting fasteners and/or failure to tighten them correctly can
result in winch pulling off suddenly and unexpectedly during high loads, which may cause load to drop,
possibly resulting in severe injury or death.
WARNING! Winch can only be aligned one way. Ensure stripper arm is aligned correctly according to the
diagram. Incorrect alignment of the stripper arm can cause the rope to fall out of the jaws, leading to release
of load, possibly resulting in severe injury or death.
WARNING! Ensure rope guide is aligned correctly according to the diagram. Misalignment of the rope guide can cause
rope overrides, and loading stress, leading to loss of control, possibly resulting in severe injury or death.
11. Reassemble drum, stripper arm
and socket. When the rope guide is at 7
o'clock, the stripper arm should point to
11 o’clock (330 degrees approx).
Harken accepts no responsibility for
defective installation or reassembly of
its winches. If you have questions or
concerns, Harken Tech service is at your
disposal at info@harkenindustrial.com
Handling
Protect against extreme temperatures: -10° C to +40° C
Extreme heat may distort composite parts.
Extreme cold can cause the material to become brittle and cause the lubrication to congeal.
Storage
Store in clean/dry place
Avoid impact damage which could damage jaws and skirt; ensure good packaging when shipping.