19
Radial Winch
60.3 ST EL/HY
Installation and Maintenance Manual - Mod.E
Assembly
Make sure that the holes and drainage channels in the base of the winch are not obstructed.
Assemble the winch in the reverse order of the sequence in the section on disassembly.
To tighten bolts, use the torque indicated in the disassembly procedure.
In case of doubt concerning the assembly procedure contact Harken® Tech Service:
[email protected]
The icon on the Stripper Arm Housing
indicates the Stripper Arm final position.
Change the Stripper Arm Housing angle
to modify the Stripper Arm final position.
When positioning the stripper arm, align
the peeler with it.
If the jaws have been disassembled,
insert peeler between the two jaws, taking
care that the letters TOP on the peeler
are facing upwards.
OIL
To assemble the clutch pin
Mount the spring with the pin pointing
upwards so that it is wound in an anti-
clockwise direction starting from the pin.
To assemble the pawls
Correctly position the spring in its housing
as shown at left. Hold the spring closed
and slide the pawl into its housing. Once
in position, check that the pawls can be
easily opened and closed with a finger.
NOTICE
Before screw the central screw, check
the correct position of the o-ring in the
assy socket and apply Harken
®
grease.
