13
F.
CARE AND MAINTENANCE
Warm soapy water is recommended to be used to wipe down the surfaces of the appliance.
CAUTION – You must let the appliance cool down before you clean it.
NEVER douse the Jet-Pro Cooker with water when the surfaces are hot.
DO NOT submerge in water.
DO NOT allow water to enter into the burner outlets or aeration holes
1. CARE OF BURNERS
Ensure that there are no signs of blockage (debris, insects) in either the burner portholes, the
primary air inlet, or the neck of the burner. Use compressed air or a pipe cleaner wire to clear
obstructions. A wire brush can be used to remove corrosion from the burner surfaces.
On the burner outlet is an adjustable air shutter. This has been factory set and should not
need to be adjusted.
Adjusting this allows more or less air to enter the burner which will adjust the flame
composition.
2. STORAGE
Store your Jet-Pro Cooker in a cool dry place. Cover the burner with aluminium foil in order
to prevent insects or other debris from collecting in burner holes. The gas cylinder should be
disconnected from the Jet-Pro Cooker and stored outdoors. When using the Jet-Pro Cooker
after extended periods of storage, please follow all of the care and maintenance instructions.
Cylinders must be stored outdoors in a well ventilated area out of the reach of children. Any
indoor storage shall comply with Section 2 Minor storage and usage of AS/NZS 1596.
After use, the gas control valve, hose and regulator assembly must be removed from the Jet-
Pro Cooker and stored safely until the next use of the Jet-Pro Cooker.
WARNING: Ensure any covers are removed prior to operating the Jet-Pro Cooker.
It is recomended that the Jet-Pro Cooker be serviced by an authorised gas technician every
24 months.
