FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.
This appliance has a pilot, which must
be lit by hand. When lighting the pilot,
follow these instructions exactly.
B.
BEFORE LIGHTING
smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
:
1. Do not try to light any appliance.
2. Do not touch any electric switch; do not
use any phone in your building.
3. Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
supplier’s instructions.
4. If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or
turn the gas control knob. Never
use tools. If the knob will not
push in or turn by hand, do not try
to repair it. Call a qualified
service technician.
D. Do not use this appliance if any
part has been under water.
Immediately call a qualified
service technician to inspect the
appliance and to replace any part
of the control system and any gas
control, which has been
underwater.
LIGHTING INSTRUCTIONS
GAS OUTLET
GAS INLET
Pilot Adjustment
Screw
Pilot Gas
Supply
4. Find pilot – follow metal tube from the gas control
behind the burner pan.
Pilot Burner
Thermocouple
1. STOP! Read the safety information above on
this label.
2. Push in gas control knob slightly and turn
clockwise to
“OFF”.
CONTROL
KNOB
NOTE: Knob cannot be turned from “PILOT” to
“OFF” unless knob is pushed in slightly. Do not
force.
3. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above. If you don’t smell gas, go to
next step.
5. Turn knob on gas control counter-clockwise to
“PILOT
”.
6. Push in control knob all the way and hold in.
Immediately light the pilot with a match.
Continue to hold the control knob in for about one
minute after the pilot is lit. Release knob and it
will pop back up. Pilot should remain lit. If it
goes out, repeat steps 3 – 7.
* If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
*
If the pilot will not stay lit after several tries, turn
the gas control knob to
“OFF”
and call your
service technician or gas supplier.
7. Turn gas control knob counterclockwise to
“0N”.
LIGHTING INSTRUCTIONS
1. Turn knob clockwise from
“ON”
position to the
“PILOT”
position. Push in the gas control knob slightly
and turn clockwise to
“OFF”
. Do not force knob.
10
