Closed Eye Bolts
for Lifting the
Platform Scale
Hardy Floor Scales
5
FIG. 1 INSTALLING THE CLOSED EYE-
BOLTS INTO THE TOP PLATE
COMPONENT
DESCRIPTIONS
1.
Steel Plate Platform
- The platform material is
either painted carbon steel or 304 stainless steel.
The carbon steel platform cover is made from a
single piece of 1/4" A36 carbon steel floor plate
(skid resistant) or smooth steel plate. The steel
platforms are primed and coated with a tough
weather resistant paint (See Paint Specifications).
The 304 stainless steel platform is made from a
single piece of 1/4" diamond tread (Conforms to
ASTM A793-85) floor plate (skid resistant) or
smooth stainless steel plate with a bead blast fin-
ish.
2.
Summing Junction Card Assembly
- Accessed
by unfastening the 2 screws on the deck plate on
the center side of the platform. (See Fig.2) The
summing junction card routes the excitation volt-
age to each of the four load sensors and sums the
weight signal back from them. The C2
®
second
generation electronic calibration is included with
your scale.
For Class I and II, Division 1 Hazardous (Classi-
fied) Locations, and Class 1, Zone 0 and 2
Groups IIC, Zone 20 and 22 Groups IIIC, power
must be supplied to the Summing Box through
approved intrinsically safe barriers per control
Summary of Contents for HIFS-3030-01-PS-T
