Loading process
The cPH2 is designed to charge your vehicle as quickly as possible. However, the
effective charging time depends on the vehicle battery, as well as the current residual
energy in the vehicle. A binding statement on the charging time is therefore not possible:
You can therefore only conclude the actual charging time yourself from your practical
experience values.
If a fault should occur during the charging process or afterwards, this is indicated via the
LED status display of the cPH2. The chapter Status LED, page 22, describes how to
recognize operating and error states and what measures are necessary.
To charge your vehicle, proceed as follows:
1.
check the LED status indicators on the front of the cPH2:
When the charging station is ready for operation, the LEDs on the front of the charging
station light up green.
2.
Open the charging socket on the vehicle.
3.
Plug the charging coupling of the charging cable into the charging socket on the
vehicle.
The vehicle must be parked so that you can easily reach the socket on the vehicle.
The cable must
not
be under tension during the charging process.
4.
if available on your model, open the cover of a charging socket on the cPH2 and insert
the type 2 charging plug.
NOTE!
If you equip your Wallbox with RFID authentication or an OCPP Backend
please note points 5 and 6. Otherwise, charging takes place immediately
after plugging in. (The LED changes from "green" to "yellow" (vehicle
connected) to "blue" (charge active).
5.
Log on to the Wallbox with a valid RFID card (one of the 5 RFID cards supplied ex
works). Hold the card in front of the card reader of the Wallbox for approx. 3 seconds. A
short beep will sound to indicate that the card has been successfully recognized.
Immediately afterwards, you will hear another tone:
· short tone (approx. 1 second) for card accepted
· long tone (approx. 3 seconds) for card rejected
More information about the RFID module on page 21.
Installation and operating manual
cPH2
charging station
Version: 1.0.9
19
