STEP 2 - Install Mounting Brackets
STEP 3 - Install Lift Arms
Install Mounting Brackets at desired height with twelve (12) #8 x 1/2” Flat Head Phillips Wood Screws
provided.
NOTE: If using a pre-drilled 32mm system, the front of the bracket can be mounted using 5mm Euro screws.
Install RH and LH Lift Arms by sliding into the brackets as shown. NOTE: Depending on the room
available, it may be necessary to fold down the Lift Arm before install. (PROCEED WITH CAUTION.
Lift Arm is under extreme pressure). Once fully seated in the Mounting Bracket, install one (1) #8 x 1”
Flat Head Phillips Wood Screw in the rear top hole of each Lift Arm to secure it in place.
STEP 2 - Install Rail and Pole
STEP 3 - Install Handle and Final Adjustments
LOOSEN
TIGHTEN
A
A
B
C
J
I
H
F
G
E
D
LOOSEN
TIGHTEN
A
B
C
K
H
F
G
E
D
Attach the Side Brackets to the Adjustable Rail with the two (2) #8 x 1-3/8” Flat Head Allen Machine
Screws provided. With Lift Arms in the down position, adjust the Adjustable Rail so that the Side
Brackets slide onto the ends of the Lift Arms as shown and tighten Side Brackets with Allen Wrench
provided. Slip the Adjustable Pole into the T-Bracket and fasten using one (1) #3 x 3/8” Pan Head
Screw.
Operate the lift by gently pushing upward on the handle. Check clearance of Adjustable Rail from
side to side and adjust accordingly. Center the T-Bracket on the Adjustable Rail and slide the rubber
O-rings tight against both sides of the T-Bracket to hold it in place. Adjust Handle Pole to desired
length as shown.
15xxSC12/15 v.1
#8 x 1” Flat Head
Phillips Wood Screw
#8 x 1/2” Flat Head
Phillips Wood Screws
