Page 16 of 22
CUS-013-0028-09
Instructions for the Auto Clean Operation
1. Check that the level of degreaser is enough to run the Auto
Clean cycle as shown in Figure 5-1
2. If the level is too low, replace the bottle.
Figure 5-1
Figure 5-2
REFER TO YOUR COMPAN
Y’S POLICY ON THE HANDLING OF
HAZARDOUS MATERIALS WHEN REPLACING THE
DEGREASER BOTTLE; FOR MORE INFORMATION, CONSULT
THE DEGREASER’S MATERIAL SAFETY DATA SHEET.
3. Open the door to the rotisserie.
4. Using a metal or plastic scraper, scrape and discard the
layer of debris from the bottom pan. If this layer is fluid, it
would be helpful to use some type of shallow pan/bowl to
scoop the debris into.
DO NOT PUSH SOLID DEBRIS INTO THE DRAINS.
5. Using a wet towel, clean the front channel, exterior panel
and the inside door glass pane.
6. Rotate the Manual Drain Valve Handle to Clean
as
shown in Figure 5-2.
7. Close the rotisserie door and press CLEAN
and then
ENTER
to start the cleaning cycle. Read the display. If
the Auto Clean has begun it will read either,
“CHECKING
OVEN TEMP
ERATURE”, “CLEAN COOLDOWN”
or
“PREWASH”.
8. Clean the outside of the rotisserie following the conventions
outlined in section
If the display reads,
“CLEAN COOLDOWN”
the Auto Clean will not start immediately as the cooking
cavity is too hot. DO NOT open the door to cool the rotisserie! It must cool on its own with the door
closed for optimal Auto Clean performance and to avoid damaging the inside of the oven.
The Auto Clean will start on its own when the rotisserie has properly cooled.
For rotisseries equipped with the optional sensors
– If the degreaser is low, an alarm will sound and the
display will show:
“REFILL DEGREASER BOTTLE // PRESS CLEAN”. Replace the degreaser bottle and start
again.
If the display shows:
“CLOSE DRAIN VALVE // PRESS CLEAN”, the Manual Drain Valve Handle is not fully
closed. Close it and start again.
MINIMUM LEVEL IN
BOTTLE:
WITH SOIL SHIELD: 2.25”
WITHOUT SOIL SHIELD: 3”
USE ONLY ECOLAB CIP OR
HARDT CLEAN 3000
