10
www.hardlifeutility.com
BACK WALL ASSEMBLY
1. Install both end panels’ base plate at the side (component code 8) and both end panels’ base plate at the
middle (component code 8B), as shown in
Figure 5
. Secure the 8 and 8B base plates using two 450 mm
stake pegs (component code 34) each, as shown in
Figure 5
.
2. Insert the standing legs at the side (component code 9) into the end panels’ base plate at the side (compo-
nent code 8), as shown in
Figure 5.
The standing legs (component code 9) are connected to the arch using
clips (component code 37), as shown in
Figure 5.
3. Insert the lower standing legs at the middle of the back panel (component code 15) into the end panels’
base plate at the middle (component code 8B), as shown in
Figure 5
. The bottom of the standing legs is
narrower than the short tubes that are welded on the base plates and can be inserted into it.
4. Install the bottom tensioning tubes at the back panel (component code 18), as shown in
Figure 5.
NOTE:
•
Plug both the ends of the bottom tensioning tubes with plastic plugs, if available.
•
There are clips on the base plates to fix the bottom tensioning tubes, as shown in
Figure 6.
Figure 5
Summary of Contents for C2020
Page 2: ......
Page 15: ...14 www hardlifeutility com ...
