Hardi MASTER HVZ Series, Instruction Book

Page: 15 / 48

15
GB 05 03 MA
Sprayer setup
Shor Shor Shor Shor Short outer section (2) t outer section (2) t outer section (2) t outer section (2) t outer section (2)
Adjustment is carried out as described above in the
section
‘Large outer section ’.
Br Br
Br Br Break
eak
eak eak eaka
aa
a aw
w
w w wa
aa
a ay section
y section
y section y section y section
The height of this section should be adjusted if it hangs
down compared to the rest of the wing.
Align section be means of bolted joint
F .
T102-0031
F
T102-0032
Centr Centr Centr Centr Centre par e par e par e par e part - setting of t - setting of t - setting of t - setting of t - setting of tr tr tr tr tra aa a ape pe pe pe pezzzzze ee e e
In order to alter the behaviour of the boom the trapeze
has 4 settings.
Setting 1 : For use on uneven ground with many obsta-
cles.
Setting 2 : All-round standard setting (Factory setting)
Setting 3 : Slightly slower mowing trapeze. Good at
following slopes, but less compensating for
obstacles.
Setting 4 : Very slow moving trapeze. For use on even
ground and slopes where there are no
obstacles.
How to alter the setting
1. Unfold and support the boom.
2. Loosen bolt from locking hole (
A ).
3. Remove pin + mounting ( B ).
4. Place ( B ) in new setting position (1-4).
5. Fasten bolt in locking hole ( A ) again.
NOTE! To change from pos. 1 or 2 to pos. 3 or 4 - or
vice versa - the pin + mounting ( B ) must be fastened by
the bolt in the opposite hole. In this case = C.
Carry out similar adjustments to both sides of trapeze.
T102-0023
1
2
3
4
T102-0024
A
B
C