Hard Head 017295, Operating Instructions Manual

Page: 22 / 23

EN
22
NOTE:
Tap on the supports close to the joints to lock
the parts in place.
5. Fasten one of the short shelf supports (C)
in the upper holes in two of the angle
brackets (A). Tap in the pins at the bottom
in the key-shaped holes by tapping
close to the joint with a rubber mallet.
Make sure that the support is correctly
positioned.
6. Repeat for the other two angle posts. The
top parts are now ready
FIG. 4
7. Place the post inserts (F) in the angle
posts (A) on the bottom part.
8. Put the top part on the post inserts (F).
FIG. 5
9. Fit a short shelf support (C) over the joint
by tapping in the upper pin in the lower
key-shaped hole in the top part and the
lower pin in the upper key-shaped hole
on the bottom part. Tap in the pins at
the bottom in the key-shaped holes by
tapping close to the joint with a rubber
mallet.
10. Repeat the last step to assemble one
other short shelf support (C) and two long
shelf supports (B).
FIG. 6
11. Fit two long shelf supports (B) at the top
of the angle posts (A). Check that the pins
rest against the holes before tapping on
the supports to drive in the pins.
FIG. 7
12. Fit the remaining shelf supports (B and
C) at the required heights for other two
shelves. Tap on the supports close to the
joints to lock the parts in place.
FIG. 8
NOTE:
The crossbars and shelves can be fitted in
steps of 3.8 cm to the required height.
13. Place the shelves (D) on the shelf supports.
14. Fit the post caps (E) on the ends of the
angle posts (A).
1. Shelf
2. Shelf support
FIG. 9
IMPORTANT:
Check that the shelf supports are correctly
assembled.
ALTERNATIVE 2: WORKBENCH
1. Assemble the bottom part as per steps 1
to 4 above.
2. Fit two short and two long shelf supports
(C and B) in the upper holes in the angle
posts. Tap in the pins at the bottom in the
key-shaped holes by tapping close to the
joint with a rubber mallet.
3. Fit another two short and two long shelf
supports (C and B) at the required height.
FIG. 10
4. Fit one short shelf support (C) in the
upper holes in two of the angle brackets
(A). Fit another short shelf support in the
7th and 8th holes from below in the angle
posts. Tap in the pins at the bottom in the
key-shaped holes by tapping close to the
joint with a rubber mallet.
5. Repeat on the opposite side.
FIG. 11
6. Fit two long shelf supports (B) at the top
of the angle posts (A) and two long shelf
supports in the 7th and 8th holes in the
angle posts. Tap in the pins at the bottom
in the key-shaped holes by tapping close
to the joint with a rubber mallet.
FIG. 12