SKU 91240
Page 5
4.
Identify the Front Axle Support (8). Align it with the three predrilled holes on
the underside of the Tray (1). Install Bolts, Lock Washers and Nuts (16) as
before. You may now tighten all bolts and nuts for the Front Axle Support (8).
DO NOT OVERTIGHTEN: Check to be sure that the bolt heads do not
damage the plastic Tray (1) as you tighten.
5.
Attach each of the four Wheels (4) onto the axles. Slide each Wheel onto an
axle end, with the inflation valve of the wheel on the outside. Slide one of the
Washers (15) onto the end of the axle, and install an Acorn Nut (15). Tighten
the nut on each wheel in turn.
6.
Install the Handle (13) by positioning
the Plastic Coupling (12) into the
end of the Yoke (10) as shown in
the photo. Insert the Handle
Fastener Bolt (18) through the Yoke
(10), and Plastic Coupling (12).
Place the Washer and Nylock Nut
from the Fastener Set (18) onto the
Handle Fastener Bolt, and secure.
NOTE: Do not overtighten the
Nylock Nut, the handle must still be
able to move up and down freely in
the Yoke.
7. With the wagon right side up, install
the wooden sides. First place the Side
Panels (2) and the Front and Rear Panels
(3) into the slots on the sides of the Tray
(1) as shown in the Assembly Drawing,
with the vertical slats on the outside.
Secure the corners of the sides together
using the Clips (14). WARNING: Be
careful not to pinch your fingers when
installing the clips. Slide them over the
corners of the sides as shown in the
photo.
