Page 5
For technical questions, please call 1-888-866-5797.
Item 70030
6.
Mount the Tape Light
by carefully removing the thin
paper liner from the adhesive strip on the back of
Tape Light. Do not to remove the sticky backing.
7. Carefully place the sticky side of the strip
onto the cleaned surface and apply pressure
to the entire length to ensue adhesion.
Note: Choose placement carefully.
Once
the Tape Light has adhered to the surface,
it should not be repositioned.
Removing paper liner from Tape Light
8.
Connect the IR Controller
to the Tape Light by
lining up the arrows molded into the top of each
cable connector and pushing them together.
IR Controller
Tape Light
Arrows
Note:
If desired, the IR Controller may be mounted
using the double-stick foam tape attached to its back.
Carefully pull off the thin paper liner to expose the
sticky surface and press it to the mounting surface.
9. Once the Tape Light is in place and the IR Controller
is connected,
connect the Power Adapter
and plug
it into an AC outlet. Be sure the Sensor is exposed.
Power
Adapter
IR Controller
Sensor
Operation
1. Remove the battery pull tab.
2. Point the top of the Remote Control at
the IR Controller and turn on the Tape
Light by pressing the ON button.
Note:
The Remote Control must have a direct line of
sight and be within 20 feet of the IR Controller’s Sensor.
3. On the Remote Control, the top section of 24 buttons
control the intensity of
Color
output. To adjust
color, press the ON button in the “Color” section and
press the desired color button. Hold down the Dim/
Brighten button until reaching the desired intensity.
4. The middle section of 8 buttons control the
brightness of the
White light
output. To adjust,
press the ON button in the “White” section and
press one of the
%
buttons or hold the Brighten/
Dim button until reaching the desired brightness.
Note:
When the “White” section is turned
ON, the “Effects” section is deactivated.
5. The bottom section of 8 buttons control the
Effects
of cycling through color changes with varying
degrees of fading or jumping from one color to the
next. To use, press the action button desired.
a. Jump 3: Lights flash on/off while cycling through
the three main colors (red, green blue).
b. Fade 3: Lights fade in/out while cycling through
the three main colors (red, green blue).
c. Jump 7: Lights flash on/off while
cycling through seven colors.
d. Fade 7: Lights fade in/out while
cycling through seven colors.
e. Flash: Lights flash on/off while cycling
through the three main colors, then seven
colors, and then the cycle restarts.
f. Auto: Lights flash on/off, then fade in/out
though the three main colors, then seven
colors, and then the cycle restarts.
g. Quick, Slow: Press and hold to adjust
the speed of the flash and fade.
6. Turn off the Tape Light by pressing the OFF button.
Remote Control
Color
White
Effects
