SKU 93293 For technical questions please call 1-800-444-3353. Page 2
2.
Observe work area conditions. Keep work area well lighted.
3.
Store idle equipment. When not in use, the Digital Caliper must be stored
in a dry location. Always lock up products and keep out of reach of children.
4.
Use the right product for the job. There are certain applications for which
the Caliper was designed. Do not modify the Digital Caliper and do not use
the Caliper for a purpose for which it was not intended.
5.
Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for any broken or damaged
parts and any other conditions that may affect its operation. Replace or
repair damaged or worn parts immediately.
6.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
7.
Do not operate product if under the influence of alcohol or drugs.
Read warning labels on prescriptions to determine if your judgment or reflexes
are impaired while taking drugs. If there is any doubt, do not operate the
product.
8.
Use eye protection. Always wear ANSI approved impact safety goggles.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Digital Caliper, check to make sure that the product is intact
and undamaged. If any parts are missing or broken, please call HARBOR
FREIGHT TOOLS at 1-800-444-3353.
Operation
Your Digital Caliper requires no assembly. It is important that you read the entire
manual to become familiar with the product BEFORE you use the Digital Caliper.
Do not bump or shock the tool when applying it to any work piece. Rough
treatment may damage the highly sensitive mechanism.
Measuring the Outside of an Object
1.
Push the “On” Button (see Figure 1) to “ON”. To change the setting from
inches to millimeters, press the ON/Inch/mm button. Each time the button is
pushed the mode will change. Slide to separate the sides of the Caliper.
Slide the object you wish to measure in-between the inside or the outside
jaws on the Caliper - see Figure 1.
2.
The LCD readout will measure the distance between the jaws as the object
is measured. Press the “Zero” button to set the readout to 0. The LCD
readout will show the measurement in either inches or mm. Press the “Off
button” to turn off when finished using.