9.
Do not use this product if under the influence of alcohol or drugs.
Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any
doubt, do not operate the product.
10.
Use eye protection.
Always wear ANSI approved impact safety goggles.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be supplied
by the operator.
Assembly
Your Magnetic Base will require some assembly as described in the following steps. To assist you with as-
sembly and operation please refer to the Parts List located on the last page of this manual.
Step 1)
Thread the Upright Post with Lock Nut (#2) onto the Base (#1).
Step 2)
The Upright Post Swivel (#3) should be slid into place on the Upright Post with Lock Nut
(#2). Turn the Upright Post Swivel clockwise to secure it in place. Insert the Snug Gauge
Rod (#4) through the Upright Post Swivel (#3).
Step 3)
Slide the Indicator Clamp (#5) onto the Snug Gauge Rod (#4).
Operation
Settings and Adjustments
When making adjustments, make certain that all thumbscrews are fully tightened and Swivels are secure
when adjustments are complete.
The Magnetic Base can be attached to flat or round surfaces. For use on a Q.A. table, it can reach out 12”. It
can be set to many different positions.
Step 1)
Set the Base (#1) in the desired position. Turn the Dial counterclockwise to “ON” to engage
the Magnet.
Step 2)
Loosen the thumbscrew on the Upright Post Swivel (#3) and move the Upright Post Swivel
(#3) and the Snug Gauge Rod (#4) to the desired location.
Step 3)
Position the Indicator Clamp (#5) as desired.
Step 4)
Turn the Fine Adjustment (#6) knob to fine tune the position of the Snug Gauge Rod (#4).
#5645
Page 3
Brought to You by Augusta Flint