Page 9
SKU 97028
For technical questions, please call 1-800-444-3353.
Turn on the Air Compressor (not included) and set it to 90 PSI. Do not exceed
1.
maximum air pressure of 100 PSI.
Before planishing, test the operation by pressing down on the Foot Pedal (26).
2.
Adjust the cycle speed of the Planishing Hammer by turning the Regulator (4)
3.
clockwise or counterclockwise.
Using both hands, place the material to be planished between the Anvil Head
4.
(21) and the Hammer Shank (23).
Press down on the Foot Pedal (26) to opperate planishing action.
5.
When finished, remove your foot from the Foot Pedal (26) and wait for the action
6.
to stop completely.
Turn the air compressor off.
7.
Press down on the Foot Pedal (26) to release any remaining air pressure within
8.
the Planishing Hammer.
To prevent accidents, always disconnect the air supply after use. Clean, then
9.
store the tool indoors out of children’s reach.
maiNTENaNCE aNd sErViCiNg
risk of serious personal injury, unplug the tool from its air
supply before performing any inspection, maintenance, or
cleaning procedures.
damaged equipment can fail, causing serious personal
injury. do not use damaged equipment. if abnormal noise or
vibration occurs, have the problem corrected before further
use.
Cleaning, maintenance, and lubrication
BEFOrE EaCH usE,
1.
inspect the general condition of the tool. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged air hoses, and any other condition that may affect its safe operation.
aFTEr usE,
2.
clean external surfaces of the tool with clean, moist cloth.
WarNiNg! if the air hose is damaged, dO NOT attempt to repair it. it must
3.
be replaced.
WarNiNg
OPEraTiNg iNsTruCTiONs
