Page 8
SKU 95781
For technical questions, please call 1-800-444-3353.
WARNINg!
Make sure the Power Switch of the Timer is in its “OFF” position
and that the Pet Water Fountain is unplugged from its electrical outlet before making
any adjustments to the unit.
Insert the Pump (11) into the Base (1). Fit the Clear Tube (12) into the holding slot
in the Base. Then, place the Pump’s Power Cord in the wire holders along the side
of the Base.
(see Figure A.)
FIgURE A
FIgURE b
PUMP (11)
PUMP POWER CORD
CLEAR TUBE (12)
CLEAR TUBE (12)
Make sure all Tubes are properly connected. Remove any sharp bends or kinks in
the Clear Tube (12) or water flow could be reduced.
(see Figure b.)
FILTER (3)
FIgURE C
Align the Filter (3) into the corner slots of the Base (1) and press the Filter down
into the water chamber. Use the correct slot, and do not use excessive force.
(see Figure C.)
Feed the Power Cord of the Pump (11) through the square hole in the back of the
Water Tank Stand (16). Make sure the Power Cord is secured by the wire holders
on the side of the Base (1).
(see Figure d, next page.)
1.
2.
3.
4.
5.
