SKU 90783
PAGE 4
The Map Distance Measurement Mode:
1. The
default scale of the Measurer is 1:1000000 (note: this scale is without unit). If the map to be measured is not
in this scale, an appropriate scale should be set. If the scale is 1:1000, then input1000 for setting the scale.
2. On some older maps, there may be a different kind of scale format with a unit such as 1” = 10 miles. If so, then it
will be necessary to change miles into inches (note: 1 mile = 63359.9”). First change 10 miles into 633599”. Then,
set the proper scale as 1:633599.
3. Press the Scale Key, and the Time Display Mode will read as follows:
(See Figure L.)
0.
FIGURE L
4. Input the actual figure on the map according to the map’s scale, and press the “=” Key on the Keyboard to confirm
the scale setting. All measurements will now be based on this scale. Return to the default scale by pressing RESET.
5. To measure the distance, press MEASURE
once and the Time Display Mode will
read as follows: (See Figure M.)
0.
o
KM
FIGURE M
6. Press CE to switch between KM and MILE. Place the Measuring Gear Wheel on the
start point on the map. Push the Measuring Multi-Tool along the route from the start
point to the end of the route. NOTE: Press down on the Measuring Multi-Tool with
some force to make sure the Measuring Gear Wheel rolls along the entire route. (See Figure A.)
7. When the Measuring Gear Wheel meets the end of the route on the map, the number displayed on the Time
Display Mode is the actual distance. (See Figure M.)
The Light Mode:
1. Press the Light Switch button on to turn on and turn off the Light.
(See Figure A.)
The Compass:
1. Turn and hold the Measuring Multi-Tool upside down to read the Compass.
The Batteries:
1. Two G13-A
or LR-44 type Batteries will power the Measuring Multi-Tool.
2. After changing the Batteries, you must press RESET and set the time again.
INSPECTION, MAINTENANCE, AND CLEANING
1. Before each use, inspect the general condition of the Measuring Multi-Tool. Check for any condition that
may affect the proper operation of the product. If a problem occurs, have the problem corrected before
further use. Do not use damaged equipment.
2. To change the two Batteries, remove the Battery Door. Remove the old Batteries. Insert the new Batteries.
Then, replace the Battery Door. (See Figure A.)
3. When cleaning, wipe the Measuring Multi-Tool with a dry, clean cloth, taking care not to accidentally press
the Keys on the Keyboard. Do not immerse this product in liquids.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES
ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL RE-
PAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNI-
CIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR
HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Note: No replacement parts are available for this product.
Note: Batteries with low charge can affect accuracy of tool.
90783 manual.p65
11/17/03, 2:34 PM
4