Page 13
For technical questions, please call 1-800-444-3353.
SKU 66908 / 66909
Chart below for proper mix quantities.
nOte:
Mix only enough fuel for
a few days work. The maximum
storage time of mixed fuel is 3
months.
FueL Mix quantities
Ratio
2 Stroke
Engine Oil
Unleaded Gasoline
(90 Octane)
40:1
3.2 Fl. Oz.
1 Gal.
40:1
6.4 Fl. Oz.
2 Gal.
Figure 3
3. Once the proper fuel mix is obtained,
wipe gas cap and its surrounding
area, then remove the Gas Cap. Fill
the Fuel Tank up to the lip of the
opening with the fuel mix. Then,
securely replace the Gas Cap.
note:
Inspect the Fuel Cap O-Ring each
time you fill the tank. Replace if
cracked, cut or leaking.
general Operating instructions
before starting the chain saw
Add Chain & Bar oil (not included)
1.
and the Gas/oil mixture (not
included).
Check the Saw Chain Tension and
2.
adjust if necessary (See Tool Set Up).
Be ready to cut before starting the
3.
Chain Saw. Stand in front of the wood
to be cut with your feet firmly in place.
Locate the Power Switch so you
4.
will know how to turn off the engine
immediately if needed.
Place the Chain Saw on the ground
5.
while starting the engine.
warning!:
Do not start the engine
while holding the chain saw above
the ground. You may loose control
when the engine starts up and cause
injury to yourself. ALWAYS follow the
Starting Procedure with the Chain
Saw placed on the ground.
starting procedure
For Model 66908 only, push the
6.
Prime Valve 5 times.
Pull out the Choke.
7.
Place your foot on the bottom of the
8.
Rear Handle to hold the Chain Saw
firmly in place on the ground while
starting the engine.
Pull the Starter Cord 4 or 5 short pulls
9.
to get gas and air in the engine.
Turn on the Power Switch.
10.
Push the Choke half way in.
11.
Pull the Starter Cord quickly and
12.
firmly several times until the engine
starts.
Push the Choke all the way in.
13.
REV 09j
