SKU 43476 PAGE 6
Troubleshooting:
1.
If the bead is broken along the sealed edge of the bag, this indicates the length
of heating time is set too long. To shorten the heating time, turn the Timer Knob
counterclockwise.
2.
If the edge of the bag does not seal, this indicates the length of heating time is set
too short. To lengthen the heating time turn the Timer Knob clockwise.
3.
If the bag sticks to the Teflon Cloth of the Sealer, this indicates the Heat Element
has not had sufficient time to cool. After the Panel Light automatically shuts off
continue holding the Handle in the downward position for another 1-2 seconds,
until the Heat Element completely cools, before removing the bag.
CLEANING AND MAINTENANCE
1.
ALWAYS disconnect the unit’s 3-Prong Electrical Cord Plug from the electrical
outlet
prior
to performing any cleaning or maintenance on this product.
2.
To replace the Teflon Cloth (part #25), remove the 3 screws along each top of the
two Metal Plates (part #15). Remove the old Teflon Cloth and replace with the
new Teflon Cloth. Then, reattach the screws along the top of the Metal Plate.
3.
To replace the Heat Element (part #34), remove the 3 screws along each top of
the two Metal Plates (part #15). Remove the Teflon Cloth. Remove the nut
(part #40) and the screw (part #43) at each end of the Heat Element. Remove
the old Heat Element andreplace with a new Heat Element. Replace the Teflon
Cloth. Then, reattach the screws along the top of the Metal Plate.
4.
To clean, wipe unit with a clean, damp cloth. If necessary, use a mild detergent.
5.
All major maintenance and repair operations should be performed by a qualified
technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER RE-
PAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT
OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
43476 manual.p65
10/15/03, 3:16 PM
6
Brought to You by Augusta Flint
