8
INITIAL INSTALLATION
4.
3.
3
A
O
N
Set Screw
and Nut
5.
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
Start at the TOP of the hanging ball on the downrod
and measure 8 in. of lead wire, and then cut the
excess wire off with wire cutters (not included).
NOTE:
If you do
not
cut back the lead wires,
Steps
4 and 5 are not necessary and you may proceed
to Step 6 instead
.
E
Slip downrod (A) into yoke, align holes and
re-install pin (N) and clip (O). Tighten set screw
and nut. Slide yoke cover (E) down until it rests on
top of motor housing (D).
D
4
Hanging
Ball
8 in.
If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of each
wire -- WHITE, BLUE, PINK, GREY AND RED (if
applicable). Twist stripped ends of each strand of
wire within the insulation with pliers (not included).
5
