9
INITIAL INSTALLATION
11. Install hanging ball of downrod (A) into opening of
mounting bracket (C). Align one of the slots in
hanging ball with the tab in mounting bracket (C).
DANGER:
Failure to align slot in hanging ball
with the tab in mounting bracket (C) may cause the
fan to fall, which could result in serious injury or
death.
10. If you cut back the lead wires in Step 9, strip 1/2 in.
of insulation from end of each wire -- WHITE,
BLACK and BLUE. Twist stripped ends of each
strand of wire within the insulation with pliers (not
included).
10
1.
1
Replace vice (S) on safety cable (R) and adjust
length of safety cable (R) by pulling on the safety
cable (R). Adjust slack in safety cable (R) to a
hand’s length and then tighten screw and nut on
vice (S) securely. The loop at the end of the
safety cable (R) should just fit over the threads on
the wood screw (not included) used to secure it.
Test safety cable (R) by pulling on loose end of
cable with pliers. If the safety cable (R) slips, then
screw and nut on vice (S) must be set tighter.
S
Screw
Nut
Loop
Wood
Screw
INSTALLING SAFETY CABLE
R
C
Slot
11
A
Tab
