INITIAL INSTALLATION
Remove pin (D) and clip (E) from downrod (C).
Partially loosen preassembled set screws and nuts
in yoke at top of motor assembly (I).
5a.
5A
5B
Set Screw
Sideview
Yoke
6. Insert downrod (C) through canopy (F), canopy
cover (G) and yoke cover (H).
NOTE:
Canopy
cover (G) must be turned with the shiny side
toward
the motor assembly (I).
Then, thread wires and safety cable (O) from
motor assembly (I) through downrod (C).
6
7. Slip downrod (C) into yoke, align holes and
re-install pin (D) and clip (E). Tighten set screws
in yoke and then tighten preassembled nuts on
the set screws. Then, slide yoke cover (H) down
until it rests on top of motor assembly (I).
7
Yoke
E
D
Set Screw
and Nut
Sideview
5b.
8
E
I
D
C
H
G
F
O
C
D
I
H
E
C
